DIY Summer Bubble Epoxy Coaster Tutorial
Fragile bubbles can actually create fascinating patterns, and the process is surprisingly simple! Give this unique coaster a try！
Difficulty: ★★★☆☆ 
Working Time: Around 1 hour
Tools and Materials Preparation
- Materials: Coaster Resin All-in-one Kit, Soapy Water, Resin Dye, Low viscosity UV resin、
- Tools: UV Light
- Protective Equipment: Always wear nitrile waterproof gloves, a waterproof apron, and a respirator for safe handling.
Environment Setup
- Ideal Conditions: Maintain a temperature between 73–78°F with humidity no higher than 50–60% RH.
- Ventilation: Work in a well-ventilated area, ideally near a window or use an air purifier for better airflow.
Step-by-step Instructions
Step 1
Mix epoxy resin in a 1:1 ratio. Add blue transparent resin dye and stir thoroughly. Let it sit for 2 minutes or use the Air Zero Bubble Remover Machine to remove bubbles.
Step 2
Pour the mixed resin into the coaster mold until full. Let it cure for about 12 hours.
Tip: Pop the bubbles with a toothpick or quickly pass a torch over the surface. It's kindly noted to keep the torch at a safe distance to avoid melting the mold (Not recommended for beginners).
Step 3
Apply the UV resin onto the cured resin surface and spread evenly.
Step 4
Use a straw to blow soap bubbles.
Step 5
Gently lift the bubbles with a stick and layer them on the coaster surface. Cure immediately under the UV light for about 1 minute.
Tip: The bubbles pop quickly, so the trick here is quick hands!
Step 6
Apply the provided blue glitter to the surface. Done!✨
Now go ahead, get crafting and make every sip delightful!
💡Professional Tip
Epoxy Resin gets thick in cold weather, increasing unwanted bubbles in projects. Give the resin bottles a warm bath (122°F / 50°C) to restore fluidity before use.
