Dried Flowers Resin Coaster
Do you want to preserve the vibrant beauty of flowers, sprinkle your life with spring colors? In just 40 minutes, you can create three beautiful coasters with dried flowers! Ready to start creating?
Difficulty: ★★☆☆☆
Crafting Time: 40 minutes
Tools and Materials Preparation
- Materials: Epoxy Resin, Deep Pour Resin, Dried Flowers, Dried Leaves, Hot Melt Glue / UV Resin
- Tools: Stirring Sticks, Measuring Cups, Deep Coaster Mold
- Protective Equipment: Always wear nitrile waterproof gloves, a waterproof apron, and a respirator for safe handling.
Environment Setup
- Ideal Conditions: Maintain a temperature between 73–78°F with humidity no higher than 50–60% RH.
- Ventilation: Work in a well-ventilated area, ideally near a window or use an air purifier for better airflow.
Caution
| Issue | Solution | Illustration |
|---|---|---|
| What size dried flowers do I need? | For optimal results, dried flowers should be under 0.7 inches in thickness and under 2.7 inches in diameter to allow the resin to fully seal the flowers. |   |
🔍Step-by-step Instructions
Step 1
Mix the regular epoxy resin in a 1:1 ratio by volume. Pour a thin layer of resin mixture into the mold and allow it to cure for 12 hours. Then arrange the dried flowers on the cured surface. Note: All dried flowers used must be completely dry.
Tip: Use hot glue or UV resin to secure the dried flowers in place, preventing them from floating or moving when additional resin is poured.
Step 2
Mix deep pour resin at a 2:1 volume ratio. Stir slowly and consistently in a clockwise direction for about 2 minutes until there is no swirl.
Step 3
Pour deep pour resin into the mold and let it cure for 24 hours.
Tip: After pouring, gently press down on the flowers to release air bubbles. Use a stirring stick to pick up the bubbles.
Step 4
Once it is fully cured after 24 hours, demold the coaster.
Tip：If the edges feel sharp after demolding, carefully trim them with a craft knife and lightly sand with 2000-grit sandpaper for a smooth finish.
