[Holiday Gift] Shining Christmas Tree Hanging Tag

Tools and Materials Preparation

Materials：Round ornament mold、Glitter、Stickers、Ероху resin、UV resin、Miniature figurines、UV lamp

Tools: Production Tools: Mixing sticks, Measuring Cup

Protective Equipment: Always wear nitrile waterproof gloves, a waterproof apron, and a respirator for safe handling.

Environment Setup

Ideal Conditions: Maintain a temperature between 73–78°F with humidity no higher than 50–60% RH.

Ventilation: Work in a well-ventilated area, ideally near a window or use an air purifier for better airflow.

Step-by-step Instructions

Step 1

Mix epoxy resin and hardener at a 1:1 volume ratio. Stir clockwise at a steady, even speed for about 2 minutes, or until the mixture loses its silky streaks and becomes smooth.

Step 2

Add chunky glitter to the resin and stir until well mixed, then pour the mixture into the mold. Fill it to about half the height of the mold and let it cure for 12 hours.

Step 3

Once the first layer is cured, place the stickers (made with a cutting machine) onto the surface.

Step 4

If you're adding small resin decorations to the surface, use UV resin as glue. Cure it with a UV lamp to hold everything firmly in place so nothing shifts when you add the final layer.

Step 5

Pour a thin layer of epoxy resin over the surface to seal and finish the tag. Pour slowly and carefully to avoid overflow. Let it cure for 24 hours.

Step 6

Once fully cured, demold your tag. Add a festive ribbon, and it’s ready to hang on the Christmas tree!